If it is time to swap out your old water heater for a new one, you are going to want to make sure that you know the most effective and smart techniques possible for installing a new water heater in your home.
#1 Elevate the Water Heater
If at all possible, you are going to want to elevate the water heater above the floor. You could put a few concrete blocks under the heater to elevate it. Or you can set up something more permeant, and have a small concrete slab put down for your water heater.
Elevating the water heater off the ground will make it easier to perform regular maintenance tasks, such as draining and flushing your tank out. Having your water heater elevated also makes it easier to control issues such as flooding or leaks should they ever occur.
#2 Make Sure the Dain Faucet Is Easy to Locate
Next, you want to make sure that the drain faucet on the tank is easy to access. The drain faucet needs to be positioned so that it is facing forward. Test out the position of the drain, and make sure you can easily access it and that you have enough room to put a bucket under the faucet. This is going to be necessary for maintenance down the line. It will be much easier to take care of your water heater if it is positioned correctly to begin with.
#3 Check the Plumbing
You are going to need to connect your water lines to your hot water tank. When you connect the water lines, you are going to want to make sure that you test out the plumbing. Make sure that there is not any leaking water from the system. Seal up all the connects between the pipes that run from your water line to your water heater.
#4 Insulate Your Water Heater
Save yourself time and add insulation to your water heater when you install your water heater. Insulating your water heater will help reduce heat and energy lost over the long-term when you start out with an insulated water heater. Make sure that you add insulation not just to the water heater, but to the hot water lines that run from your water heater and into your home. Insulating everything will help make your new water heater as efficient as possible.
When installing your new water heater, elevate it off the ground. Make sure you can easily access the drainage faucet on the water heater. Check the plumbing and make sure that there are no leaks. Be sure to insulate your new water heater and hot water lines as well.
For more information, contact a company like Rolling Bay Plumbing.